MODEL 11 KEY OPERATOR’ S MANUAL 15
DIAGRAMA/ SCHÉMA/ FIGURE 8
VI SETTING THE BINDERSTRIP
™
END POSITION
The alignment of the Binderstrip
™
on the spine of a Fastbound
™
document
is set by the position of the small metal positioning arm.The positioning
arm is located on the right end of the cool platen (figure 1 page 3).To
change or reset the Binderstrip
™
end location:
1. Using a Philips head screwdriver, loosen the mounting screw of the
positioning arm (figure 8).
2. Move the positioning arm in the direction and the same distance you
would like the Binderstrip
™
positioned on the spine of the Fastbound
™
document.
3. Tighten the mounting screw.
4. Close the machine by pressing down on both sides of the cover until
the latch clicks and locks in position.
Comments to this Manuals